Electrolux EEKG5048 - Manual (Page 34)

34 electrolux installation instructions
4.
Close the lid of the battery holder.
Pressure testing
1. The oven injector is used as a
pressure test point. Remove the
oven furniture.
Remove oven burner box retaining
clips (one spring clip from each side)
and remove box front cover.
Replace one clip back into the right
hand side of the burner box.
Remove oven burner by removing
the spring clip from the right hand
side of the oven burner and slide
burner off injector, whilst easing it
forward and taking care not to strain
the F.S.D. phial.
2. Connect the pressure gauge to the
oven injector.
3. Check the supply pressure by
turning the thermostat on and one
hotplate tap full on and light the
appropriate burner.
The pressure should be either:-
I. For Natural Gas 20mbar
II. For LP Gas the pressure must be
set to 28 mbar for use on butane
or 37 mbar for use on propane
4. Turn off the taps, disconnect the
pressure gauge and replace oven
burner and cover, ensuring that the
F.S.D phial is correctly located into
the bracket on the burner.
5. Check operation of the oven.
Checking the grill
Place the grill pan containing the grid,
with the handle attached, into the grill
compartment. Light the grill burner by
turning the grill tap full on and pressing
the ignition button on the fascia panel.
As soon as the burner is lit the button
can be released.
Checking the hob
Fit the burner crowns and caps
ensuring that they are correctly seated.
Fit the pan supports.
Check each of the hob burners in turn
by turning the hob tap to its full on
position and pressing the ignition
button. As soon as the burners are lit
the button can be released.
Checking lid shut-off device
1.
Lift the lid
2.
Turn one hob tap to its full on
position and push the ignition
button.
3.
Close the lid. There should now be
no gas supply to the hob and the
burner will go out.
4.
Turn off the hob and lift the lid. The
gas supply should now be restored
to the hotplate, when the tap is
turned on.