Electrolux EEKG5048 - Manual (Page 35)

electrolux installation instructions 35
Checking the top oven
1. Turn the top oven thermostat control
knob to Mk.1 and press the ignition
button. As soon as the burner is
alight the button can be released.
2. When the oven burner lights up
there should be a low gas rate at
first to the oven burner, which is the
F.S.D. bypass rate.
3. When the F.S.D. phial has heated
up it opens the F.S.D. valve and the
main gas stream flows to the burner.
4. After 1 minute check that the flame
covers the full width of the burner
and is stable.
5. Set the oven control to Mk. 2, close
the oven door and check that after
about 10 minutes the flame size has
reduced.
6. Turn off the control knob and check
that the oven flames go out.
Checking the main oven
1. Turn on the oven thermostat control
knob to mark 9. As soon as the
burner is alight the control can be
released.
2. There should now be a low gas rate
to the burner, which is the F.S.D
bypass rate.
3. When the F.S.D. phial has heated
up it opens the F.S.D valve, which
allows the main gas supply to the
oven burner.
4. After 1 minute check that the flame
covers the full width of the burner
and is stable.
5. Set the oven control to Mk 2, close
the oven door and check that after
about 10 minutes the flame size has
reduced.
6. Turn off the control and check that
the oven flames go out.
General note
Instruct the user on how to use the
appliance and its ignition system. Refer
the user to the wording inside this
manual which gives advice on the safe
operation of the appliance.