EdgeStar IB450SS User Manual
Ib450ss clear ice maker owner’s manual
Advertising
Table of contents
Document Outline
- TABLE OF CONTENTS
- ICE MAKER SAFETY
- IMPORTANT SAFEGUARDS
- Before the ice maker is used, it must be properly positioned and installed as described in this manual, so read the manual carefully. To reduce the risk of fire, electrical shock or injury when using the ice maker, follow basic precautions, including the following:
- Extension CordBecause of potential safety hazards under certain conditions, it is strongly recommended that you do not use an extension cord with this ice maker.
- Recommended grounding method
- Free-standing installation:
- Recessed installation:
- Built-in installation:
- Operating Method
- Problem
- Possible Cause
- Probable Correction
- The machine won't operate.
- The icemaker is unplugged.
- Plug the ice maker in.
- The fuse is blown.
- Replace fuse.
- The icemaker power switch is OFF.
- Turn the ice maker power switch to ICE (ON)
- The ice storage bin is full of ice.
- Take away some ice cubes; make the ice-full probe is free of ice.
- The water doesn't feed in after the ice maker starts.
- The water supply tap is turn off.
- Turn on the water supply tap.
- The water supply pipe is not proper connected.
- Reconnect the water supply pipe.
- Machine makes ice, but bin does not fill up with ice
- The condenser may be dirty.
- Clean the condenser.
- The air flow to the ice maker may be obstructed.
- Check the installation.
- The ambient temperature and water temperature are high, or it is near with some heat source.
- Check the installation.
- Water is leaking out the unit.
- A few water droplets are on the door.
- Under some conditions, humidity may condense on the door. Consider moving the unit or just be more careful when you open the door.
- The water supply connection is leaking.
- Tighten fitting. See “Connecting the water line”.
- Cubes are partially formed--are white at the bottom.
- Not enough water in the water bin.
- Check if the water supply pressure is below 0.05Mpa.
- Check water supply--filter may be restricted.
- Check for a water leak at the water trough.
- Noise during operation
- The feet are not leveled and locked
- Level and lock the feet. See Leveling the Ice Maker.
- Certain sounds are normal.
- See “Normal Sounds.”
- The icemaker stops suddenly while making ice.
- The electricity is off.
- Reconnect the power supply line.
- The room temperature is out of the stated range.
- Cut off the electricity and let the ice maker stop working until the temperature returns within the stated range.
- The body of the ice maker is electrified
- The ground line isn't in the socket.
- Use the correct plug and outlet.
- Scale builds up quickly inside the machine.
- The calcium level in the water is too high.
- Use a water-softening apparatus installed in front of the water inlet valve.