Elmira Stove Works 1896 - Manual

1865-ST DUAL FUEL
Six burner range shown in Black with 4 gas and 2
smoothtop electric elements, and electric oven.
Options shown include:
• Antiquing
• Nickel door frames
• Nickel front legs
• Nickel Victorian trivet
STANDARD EXHAUST FAN
The standard 350 c.f.m. exhaust fan, included in the upper cabinet of your range, is factory-set to recirculate air through a charcoal
filter. It can also be used to outside-vent exhaust if there is not more than one 90 degree elbow or more than ten feet between the
range and the outside wall. This fan exhausts air only from the back of the range cabinet – it cannot be adapted for top-venting.
EXHAUST OUTLET LOCATION
Height from floor to center of duct opening is 62 5/8" (60 5/8" for short leg models). From left base cabinet countertop
overhang to center of duct opening is 15 3/8".
#1518 OPTIONAL IN-LINE EXHAUST BLOWER
The optional in-line exhaust blower replaces the standard 350 c.f.m. exhaust fan provided in your range cabinet, and is to be in-
stalled by your contractor where your exhaust ducting exits the house. The inline blower should be ordered when you purchase
your range - the range and wiring must be modified to accommodate the blower. (The blower can be shipped in advance of the
range for installation – additional shipping charges will apply.)
If you are outside-venting your range with more than 10 feet of ducting, or more than one elbow… or if you simply prefer a more
powerful exhaust system … you should include the optional 636 c.f.m. in-line exhaust blower. The #1518 In-Line Blower exhausts
smoke and cooking odors quickly and quietly, exiting the house up to 35 feet from the range. If desired, the blower can be mounted
in the basement or attic for powerful, whisper-quiet operation.
• The blower can be mounted vertically, horizontally or at any angle.
• Backward-curved airfoil blades move maximum air with minimal sound.
• Fan and motor are precision balanced for quiet vibration-free operation.
• Blower wiring attaches to the junction box on the back of your range.
SPECIFICATIONS:
• 636 cubic feet / minute • 210 Watts, 115 Volts, 1.85 Amps, 60 Hz • Blower length: 9-1/8"
• Blower diameter: 13-1/2" (electrical box protrudes 1-3/4"D X 4-1/2"W from side of blower) • Inlet / outlet: 8"
• Warranty: One year
IN-LINE EXHAUST BLOWER KIT CONTAINS:
• Exhaust blower with 8" inlet and outlet
• Adapter elbow – attaches to back of range, converts range outlet to 3-1/4" X 10" standard duct size.
• Duct adapter – converts 3-1/4" X 10" duct to 8" round duct
• Back draft damper with spring return – prevents cold air from entering house when blower is not in use.
• Outside louver grill – covers the exhaust outlet at soffit or foundation wall.
Louvers automatically close when the blower is not in use.
• Duct extender – mounts to back of range cabinet, replacing deflector plate.
• Duct pipe, roof flashing and roof cap (if required) are not included.
WARRANTY
One-year warranty, covering parts and labor. Additional four-year warranty (five years total) parts only on range / wall oven
burners and elements, fridge sealed refrigeration unit and compressor, and microwave magnetron tube.
NOTE RE ELECTRICAL & GAS SUPPLY
All 240 Volt ranges – standard cord is four prong 50 amp plug. Please specify if a three-prong cord is required
(home construction / wiring 1998 or prior).
All ranges - the electrical receptacle and gas piping should be installed approximately 4” above the floor and
15” from the left edge of the cabinet opening.
ALL DIMENSIONS ARE FOR PLANNING PURPOSES ONLY
Specifications are subject to change without notice. We reserve the right to make product changes as required,
without notice. Consult installation instructions before cutting cabinets, counter tops or exhaust outlet.
SAFETY & EFFICIENCY
Elmira Stove Works appliances meet or exceed the most stringent U.S. and Canadian safety and efficiency standards.
Attic In-Line Exhaust Blower Installation
The in-line blower and ducting can be mounted to or between (allowing for 14" blower di-
ameter) structural joists. Alternate installation: The exhaust duct can extend straight up
through the roof (similar to Installation #3). This method will require a roof flashing and cap,
not included.
Basement In-Line Exhaust Blower Installation
The exhaust duct runs down the wall behind the range into the basement, where it exits
through the foundation wall. The in-line blower and ducting can be mounted to or between
(allowing for 14" blower diameter) structural joists.
Roof In-Line Exhaust Blower Installation
(straight up from cabinet)
Log homes and homes with a cathedral ceiling often require a top-ducted exhaust. Advise
your dealer if you are using this application – a 7" round hole must be made in the top
center of your range cabinet. We highly recommend locating your range in the kitchen prior
to cutting the hole in the roof. (Ducting can also be routed through kitchen cabinets above
range, if desired.) 7" duct pipe, 7" to 8" increaser, roof cap and roof flashing not included.
COLORS
REFRIGERATOR / FREEZER FEATURES
CAPACITY
CABINET FEATURES
DIMENSIONS
1896 1897 1898 / 1958 1899 / 1959
Bottom Side-by-Side French Door French Door
Mount Full Depth Counter Depth
Total Fridge & Freezer (cu. ft.) 18.5 25.6 24.8 19.8
Total Fridge (cu. ft.) 12.9 16.0 17.5 14.4
Total Freezer (cu. ft.) 5.6 9.6 7.3 5.4
Fully adustable shelving * * * *
Gallon size adjustable door storage * * * *
Sealed vegetable crisper with adjustable humidity control * * * *
Deli bin with adjustable temperature control * * *
Crispers and bins made of clear durable Lexan™ * * * *
Beverage rack *
Slide out upper freezer basket * * *
Separate fridge / freezer controls * * * *
SmartWater™ ice / water filtration system through door *
Internal filtered water dispenser * *
Factory installed ice maker Optional Standard Standard Standard
EnergyStar * * * *
Energuide rating (KwH/year) 448 583 505 451
Shipping weight (lb.) 370 460 460 400
Injection molded fiberglass doors with enamel coating • • • •
Adjustable rollers provide easy movement for cleaning • • • •
Sculptured door handles • • • •
Coil free back, clean-free condenser • • • •
Left hand hinge Optional N/A N/A N/A
Standard - Black, White, Bisque • • • •
Premium - Cayenne Pepper Red, Liberty Blue • • • •
Standard Door Handles Nickel Nickel Nickel/Chrome Nickel/Chrome
Antique Brass or Antique Copper door handles Optional Optional Optional / N/A Optional / N/A
Nickel, Antique Brass or Antique Copper door frames Optional Optional Optional / N/A Optional / N/A
A Height to top of door 67-1/4" 69-3/4" 69-7/8" / 72-3/16"69-7/8" / 72-3/16"
Height to top of hinge 66-1/2" 69-3/8" 69-7/8" / N/A 69-7/8" / N/A
B Height to top of case* 65-3/4" 68-3/4" 68-5/8" / 71-15/16" 68-5/8" / 71-15/16"
C Depth not including door 28-1/4" 28" 29" 24"
D Depth inlcuding door 33-3/4" 34" 34"/ 36" 29"/ 31"
E Depth including door and handles 33-3/4" 34-1/2" 35-3/8" / 38 30-3/8" / 33"
F Depth with door(s) open 90 degrees 59-1/2" 50-1/2" 48-1/4" 43-1/4"
G Depth with freezer drawer open 52-1/2" N/A 54-3/4" / 57" 46" / 48-1/4"
H Width of case 29-1/4" 35-3/4" 35-5/8" 35-5/8"
I Width with door(s) 30" 36-3/8" 36" 36"
Width with door(s) open 90 degrees (not inc. handle) 32-1/4" 39-1/2" 42-7/8" / 46-7/8" 42-7/8" / 46-7/8"
Side clearance from wall for doors to open 90 degrees 2-1/2" 4" 4" / 6" 4" / 6"
Cutout dimensions:
Width 30" 37" 36" 36"
Height 67" 70" 70" / 73” 70" / 73”
Minimum depth 24" 24" 24" 24"
Ideal depth 28" 28" 28" 24"
A B C
D E
F
H
I
Front View TopView
A B
C D
G
REFRIGERATORS
FEATURES & SPECIFICATIONS
REFRIGERATOR DIMENSIONS
DIMENSIONS
CAPACITY
MICROWAVES & WALL OVENS
FEATURES & SPECIFICATIONS
Outside Wall Exhaust Installation
There are two options for venting an Antique range directly through an outside wall behind the range:
1. Using the standard 350 CFM fan (noted above left), the exhaust outlet on the back of the range cabinet
can be connected to standard 3-¼" X 10" ducting and vented through the wall behind the range.
2. For extra power, a 485 CFM Model 1519 wall-mounted exhaust fan can be installed on the out-
doors side of the wall, exhausting through the wall directly behind the range. The 3-¼" x 10" duct from the
back of the range must transition to 6" round to connect to the external blower. The Model 1519 blower replaces
the standard exhaust fan provided in your range cabinet, and must be ordered when you order your range.
2 15 16
1895 1880
Microwave Wall Oven
2.0 cu. ft. 5.0 cu. ft.
Overall Dimensions:
Height 14" 30-1/4"
Width 24" 30"
Depth 20" 28"
Depth with Doors, Ash Catch 33-1/2"
Cabinet Cut-Out Dimensions (Minimum):
Height 14-1/4" 28"
Width 24-1/4" 28-1/2"
Cabinet Width 30"
Depth 24" 24"
Rear Stop Depth 15-1/2" N/A
Power Source 120V, 15A 220V, 30A
Shipping Weight 65 lb. 200 lb.
Wall Oven Notes:
Allow 5-1/4" minimum
from bottom of cutout to floor.
Allow 1-1/2" minimum from top of cutout to
underside of countertop.
Wall ovens can be installed two high.
*Case cap can be removed on Models 1958 / 1959 – reduces case height by 3-5/16", to 68-5/8". Height to top of hinge with cap removed is 69-3/8".
(If necessary, allow clearance over fridge doors for overhead cabinet door swings.) Features & specifications subject to change. Contact Elmira Stove Works or visit ElmiraStoveWorks.com for updates.
Elmira_Spreads_2012_Elmira 2012-12-13 11:27 AM Page 2