Elmo EDR-X216 - Manual (Page 19)

When Preset Touring is setup for a PTZ camera, the time that the camera will remain at each preset is defined by entering the
Dwell Time value on Hardware Setup page.
To setup the dwell time for preset touring, follow these steps:
1. Click Setup on the main screen.
2. Click the Hardware Setup tab.
3. Locate the Preset Touring section at the bottom of the Hardware Setup tab. See picture below:
4. Enter a desired Dwell Time.
5. Click Save to save settings.
'
  '

)
)
%
Sensor setup is only applicable if sensors are available and are being used.
Figure 7. Sensor Setup
'
 '
 
To set up sensors, follow these steps:
1. Click Enable on the sensor you wish to activate.
2. Click NC/NO to select the type of sensor connection (NC - Normally Closed, NO - Normally Open).
3. Specify Post Recording amount if applicable.
'
  '

11