Elmo EDR-X216 - Manual (Page 39)

Figure 26. Email
Email Transmission Delay: This sets the delay time before the transmission is started after a sensor has been triggered.
Threshold: This value sets the number of lines to be included in the emails sent per day.
SMTP Server: Depending on your location, each Internet provider has specific SMTP information.
IP: The IP Address of the SMTP server. Example: smtp.bellnexxia.net
Port: Usually you do not have to change this. This is a default port for most SMTP servers. For more information on Port defaults,
please contact your email account manager.
Logon Method: "None" is a default method; otherwise, please contact your email account manager.
User name and password:Some Internet providers require user names and passwords to send out emails, if this is the case,
please enter accordingly.
'
 *
 # ! 3'
  

4
To send an alert via Email when sensors are triggered, follow these steps:
1. Click Enable Email to activate the email function.
2. Select Sensors. Sensors must be preset in the Hardware Setup prior to activation.
3. Click Video Loss to enable email transmission when video signal is lost.
4. Enter a valid Email Address. Optionally, you can enter multiple email addresses separated by commas.
'
 *
 # ! 3'
  

4
31