Enfora GSM0000PB001MAN - Manual (Page 9)

GSM/GPRS Spider SA User Manual
GSM0000PB001MAN 3 Version 1.07 - 02/14/05
2 Regulatory Compliance FCC
•
The modem was tested and certified to meet FCC Parts 15 in a stand-alone
configuration, which demonstrated that the GSM/GPRS Spider SA complies
with Part 15 emission limits. FCC Part 24 is covered by the Enfora Enabler-G
"modular approval" process for a transmitter. This approach, described by
FCC Public Notice DA 00-131407 released June 26, 2000, is intended to
afford relief to equipment manufacturers by eliminating the requirement for
obtaining a new equipment authorization for the same transmitter when
installed in a new device.
•
In order to use the GSM/GPRS Spider SA without additional FCC certification
approvals, the installation must meet the following conditions:
• For the transmitter to meet the MPE categorical exclusion
requirements of 2.1091, the ERP must be less than 1.5 watts for
personnel separation distance of at least 20 cm (7.9 in). Therefore,
the maximum antenna gain cannot exceed +3.3dBi. If greater than
1.5 watts exists, then additional testing and FCC approval is
required.
2.1 Disclaimer
The information and instructions contained within this publication comply with all
FCC, GCF, PTCRB, RTTE, IMEI and other applicable codes that are in effect at
the time of publication. Enfora disclaims all responsibility for any act or
omissions, or for breach of law, code or regulation, including local or state codes,
performed by a third party.
Enfora strongly recommends that all installations, hookups, transmissions, etc.,
be performed by persons who are experienced in the fields of radio frequency
technologies. Enfora acknowledges that the installation, setup and transmission
guidelines contained within this publication are guidelines, and that each
installation may have variables outside of the guidelines contained herein. Said
variables must be taken into consideration when installing or using the product,
and Enfora shall not be responsible for installations or transmissions that fall
outside of the parameters set forth in this publication.
Enfora shall not be liable for consequential or incidental damages, injury to any
person or property, anticipated or lost profits, loss of time, or other losses
incurred by Customer or any third party in connection with the installation of the
Products or Customer's failure to comply with the information and instructions
contained herein.