Esoteric Super Audio CD/CD Transport/36 Bit Dual Mono D/A Converter P-02/D-02 User Manual

Advanced technologies, P-02, D-02

Advertising
background image

Super Audio CD / CD Transport

35bit Dual Mono D/A Converter

A new digital link: "ES-LINK3"

The P-02 and D-02 have support for Esoteric's original transmission format "ES-LINK3" and can
perform a maximum 48-bit/176.4kHz broadband PCM digital transmission (*1) using two XLR
cables. These models also have support for "Dual AES 8Fs" standard (maximum 24-bit/352.8kHz)
(*2). These models can also perform conventional Direct Stream Digital (DSD) transmission and
direct DSD-to-analog conversion processing for Super Audio CD (SACD) playback.
*

1 The D-02 can handle inputs of signals up to 48-bit/192kHz.

*

2 The D-02 can handle inputs of signals up to 24-bit/384kHz.

35-bit D/A processing (patent pending)

The D-02 applies a completely new technology, "35-bit D/A processing" (patent pending)
algorithm. This process enhances the reproduction of analog waveforms by implementing even
finer bit gradation. In comparison with 24-bit data processing, 32-bit processing can
theoretically have 256 times higher resolution. 35-bit processing is 8 times higher than the
resolution of 32-bit processing, that is 2,048 times higher than the resolution of 24-bit
processing. The final analog output signal has a very smooth sound quality with ultimate
resolution, and a distinctive power of expression, even for extremely small signal levels.

Abundant use of high-grade components in design

Esoteric has made maximum use of high-grade components for the internal construction of
the P-02 and D-02. A total of eight independent Esoteric toroidal core power supply units are
installed in the combined system to supply clean and stable power to each circuit. The inside of
the chassis has our multiple layer structure that is partitioned into 5 sections. Each circuit block
is assembled in a dedicated compartment and placed three-dimensionally, in order to minimize
interference between circuits and to achieve the shortest signal paths. The exterior is
constructed with aluminum and a 5mm gauge steel bottom chassis, supported at four points
with Esoteric pinpoint feet (patent No. 4075477). This four-point system effectively suppresses
vibration, reduces resonance and assures extremely high rigidity.

Isolated clock technology

The P-02 and D-02 adopt an isolated clock technology that completely isolates the clock circuit
from other circuit blocks. The clock module is equipped with a dedicated toroidal core power
supply. The ground of the clock module is isolated from other circuits. As a result, this module
can supply pure clock signals to the system by completely minimizing the occurrence of
random jitter that results from power voltage or ground voltage fluctuations.
The clock module adopts high accuracy (+/-0.5ppm, at our factory prior to shipment) Voltage
Controlled Crystal Oscillators (VCXO). DAC modules and clock module are hard-wired using
special coaxial cable supplied with gold-plated SMA connectors, keeping transmission losses of
the audio clock to an absolute minimum.

Direct master clock Link without PLL

The clock sync between transport and DAC is a well established jitter reduction system, but
further advanced with a new technology called the “Direct Master Clock Link".
With the previous clock sync system, the reference clock (master clock) of the digital audio
output is generated by the transport, being synchronized to D/A processing by using PLL
(Phase Locked Loop) circuits. Esoteric's new "Direct master clock link" system is simpler and
more consistent for clock signal integrity. The 22.5792MHz master clock generated by the DAC
is supplied directly to the transport, therefore there is no need for re-clocking at the PLL circuit.
Pure and direct clocking makes sound much clearer with more accurate focus and imaging.

10MHz clock input / wide-ranging clock options

A conventional WORD clock (44.1kHz, 88.2kHz, and 176.4kHz) sync setting is also selectable, and
the system can be upgraded by adding Esoteric’ s external rubidium master clock generator. Both
the P-02 and D-02 are equipped with a 10MHz master clock input jack for connecting a
10MHz-output clock system. You can connect the units to a wide variety of optional external
clock generators for upgrading incrementally to a higher quality Esoteric sound system.

ADVANCED

TECHNOLOGIES

P-02

D-02

22.5792MHz

Master Clock

Digital Audio

Analog

35bit

34bit

33bit

32bit

Super Audio CD / CD Transport P-02 Specifications

Super Audio CD Transport

P-02

35bit Dual Mono D/A Converter

D-02

Clock module and Power supply (P-02)

Clock module and Power supply (D-02)

Compatible disc types

Super Audio CD, CD (CD-R/CD-RW compatible)

Digital Audio Output

XLR output

x 2 (Use 2 terminals for Dual AES output)

i.LINK (AUDIO) output (6-pin)

x 1

i.LINK (AUDIO) output (4-pin)

x 1

RCA coaxial output

x 1

i.LINK output format (CD)

IEC60958

Word synchronization

Jack

BNC x 2

input format

Word synchronization

Input

44.1 kHz, 88.2 kHz, 176.4 kHz,

frequencies

10 MHz, 22.5792 MHz

Input impedance

WORD IN

75 Ω

10MHz IN

50 Ω

Input level

WORD IN

TTL levels

10MHz IN

Sine wave: 0.5 to 1.0 Vrms

Input frequency range

±15 ppm

General

AC 230V 50Hz

Power supply

AC 120V 60Hz

AC 220V 60Hz

Power consumption

25 W

External dimensions

445 x 162 x 438 mm (17 1/4" x 6 3/8" x 13 1/4")

(W x H x D)

(including protrusions)

Weight

31 kg (68 3/8 lbs)

Accessories

Remote control unit (RC-1156) x 1, Batteries (AA) x 2, Power cord set x 1, Felt pads x 4

Owner’s manual x 1, Warranty card x 1

35bit Dual Mono D/A Converter D-02 Specifications

Analog audio output

Terminals

XLR (2 channels)

x 1

RCA (2 channels)

x 1

Output impedance

XLR

100 Ω

RCA

47 Ω

Maximum output level

XLR (Gain: 0 dB)

2.45 Vrms

(1 kHz, full scale, 10 kΩ)

RCA

2.45 Vrms

Frequency response(when 192kHz PCM signal input)

5 Hz to 55 kHz (.3 dB)

Signal-to-noise ratio (S/N)

115 dB

Total harmonic distortion

0.0008% (1 kHz)

Digital audio input

XLR terminal

x 2 (both XLR1 and XLR2 connectors are used for Dual input)

Input level

5.0 Vp-p

Input impedance

110 Ω

32-384.8 kHz, 16-24 bit

Dual connection

Linear PCM (Dual AES format)

Input sampling

32-192 kHz, 16-48 bit

frequencies

Linear PCM (ES-LINK3 format)

DSD (ES-LINK1, ES-LINK2 format)

Single connection

32-192 kHz, 16-24 bit

Input sampling

Linear PCM (AES/EBU format)

frequencies

DSD (ES-LINK1, ES-LINK2 format)

RCA terminal

x 2

Input level

0.5 Vp-p

Input impedance

75 Ω

Input sampling

32-192 kHz, 16-24 bit

frequencies

Linear PCM (IEC60958 format)

Optical digital terminal

x 1

Input level

24.0 - .14.5 dBm peak

Input impedance

75 Ω

Input sampling

32-192 kHz, 16-24 bit

frequencies

Linear PCM (IEC60958 format)

i.LINK (AUDIO) terminal

x 2 (6-pin, 4-pin) S400

Input sampling frequencies 32-192 kHz, 16-24 bit, Linear PCM

DSD

USB port . B connector

x 1

Input sampling frequencies 32-192 kHz, 16-24 bit, Linear PCM

PLL2 locking range

Lockable frequency range

±5 ppm for each sampling frequency

Clock output

BNC connector

×1

Output level

equal to TTL level (into 75 Ω load)

Output frequency

44.1, 88.2, 176.4, 48, 96, 192 kHz, 22.5792, 24.576 MHz

same frequency as input (when output set to thru)

Output frequency precision

±0.5 ppm (when shipped new)

Clock input

Terminal

BNC ×2 (WORD IN, 10MHz IN)

Input impedance

WORD IN

75 Ω

10MHz IN

50 Ω

Input frequency compatibility

WORD IN

44.1, 88.2, 176.4, 48, 96, 192 kHz

22.5792, 24.576 MHz (±5 ppm)

10MHz IN

10 MHz (±5 ppm)

Input level

WORD IN

equal to TTL level

10MHz IN

0.5.1.0 Vrms sine wave

General

Power supply

AC 230V 50Hz, AC 120V 60Hz, AC 220V 60Hz

Power consumption

14 W

Dimensions (W x H x D)

445 x 162 x 438 mm (17 1/4" x 6 3/8" x 13 1/4")

Weight

27.4 kg (60 2/5 lbs)

Accessories

Power cord x 1, Felt pads x 4, Warranty card x 1, Owner’s manual x 1

ESOTERIC COMPANY

1-47 Ochiai, Tama-shi, Tokyo 206-8530, Japan
Fax: (042)356-9240

www.esoteric.jp

www.esoteric.teac.com/

Please note that Esoteric products are available at limited distributors in respective countries
" ESOTERIC " is a trademark of TEAC Corporation All other brand or product names are trademarks or registered trademarks of their respective holders
©2011 TEAC Corporation. All Rights Reserved All text, images, graphics and other materials on this catalogue are subject to the copyright and other intellectual
property rights of TEAC Corporation These materials shall not directly or indirectly be published, reproduced, modified or distributed in any medium

Design and specifications are subject to change without notice. This product is available in three different power supply variations shown in the chart above.
Make sure that the voltage shown on the rear panel matches the AC line voltage in your area. The shape of the AC inlet and plug of the supplied power cord
depends on the voltage rating and destination country.

" Super Audio CD " is a registered trademark

PRINTED IN JAPAN 0911O03•TECD-0140

English version

Advertising