Making other connections – Epson POWERLITE 8350 User Manual
Page 20
20
Setting Up the Projector
Making Other Connections
Connect the power cable and other cables described below, depending on how you plan to
use the projector.
■
Plug the power cable into the projector and a grounded electrical outlet.
■
The
Trigger out
port outputs a 12-volt DC signal
when the projector is turned on. This lets a central
control system monitor whether the projector is on
or off, and can be used to raise or lower your
projection screen automatically when the projector
is in use. On the Home Cinema 8700 UB, it can
also be used to operate a motorized anamorphic
lens.
Connect a 3.5-mm mini jack to the port, as shown.
Use the
Trigger Out
setting to enable the port (see
■
To use an AV controller with the projector, connect a 9-pin null modem serial cable to
the
RS-232C
port. Refer to the table of ESC/VP21 command codes on page 69.