Quick start – Panasonic NV-GS27EB User Manual

Page 12

Advertising
background image

Before using

12

LSQT1006

Quick start

When quick start is on the battery power is still
being consumed, even when the LCD monitor
and the viewfinder are closed.
The camera will resume recording/pause mode
about 1.7 seconds after the LCD monitor or the
viewfinder is reopened.
≥Please note in quick start mode approximately

half the pause recording power is being
consumed. Using quick start mode will reduce
the battery recording/playback time.

≥This is only activated in the following cases.

≥A tape is inserted, while the Tape Recording

Mode is set.

Set to Tape Recording Mode.

1

Set [SETUP] >> [QUICK START] >> [ON].
(

-16-

)

2

While the [OFF/ON] switch is still set to
[ON], close the LCD monitor and retract the
viewfinder.

≥The status indicator lights green and the unit

goes into quick start standby mode.

≥The movie camera will not go into quick start

standby unless the LCD monitor is closed and
the viewfinder is retracted.

3

Open the LCD monitor or extend the
viewfinder.

≥The status indicator lights red and the camera

is put into recording pause approx.
1.7 seconds after it is turned on.

ª

To cancel Quick Start

1

Set [SETUP] >> [QUICK START] >> [OFF].
(

-16-

)

≥If the [OFF/ON] switch is set to [OFF] while the

unit is in quick start standby, the power turns off.

≥If the standby continues for approx. 30 minutes,

then the status indicator will go off and the
camera will be completely turned off.

≥If the Mode dial is moved or the battery is

removed in quick start standby mode, quick
start is cancelled and the power turns off.

≥When the camera is quick-started with the white

balance on automatic, it may take some time
until the white balance is adjusted if the scene
being recorded has a light source different from
the scene last recorded. (When the colour night
view function is used, however, the white
balance of the scene last recorded is retained.)

≥If the power is turned on in quick start standby,

the zoom magnification becomes 5

k and the

picture size may differ from what it was before
quick start standby.

≥If [POWER SAVE] (

-38-

) is set to [5 MINUTES]

and the unit automatically goes into quick start
standby mode, set the [OFF/ON] switch to
[OFF], then to [ON] again. Also, close the LCD
monitor and retract the viewfinder and then
open the LCD monitor or extend the viewfinder
again.

≥When using the AC adaptor, quick start can be

used even if a tape is not inserted.

MENU

OFF

ON

OFF

ON

OFF

ON

LSQT1006ENG.book 12 ページ 2005年12月9日 金曜日 午前11時17分

Advertising