Henny Penny 6 User Manual
Installation, Site, leveling
59
Installation
Refer to the following pages for important information regarding the
installation of LCS and LCG ClimaPlus Combis. It is recommended
that installation be accomplished by a certified and properly trained
technician.
NOTE: When installing a ClimaPlus combi, humidity calibration must
be performed. This process takes approximately 45-60 minutes. (page 62)
Site, leveling
1) Check for any transport damages. Should there be any signs of transport
damage immediately inform your dealer/freight forwarder.
2) Check installation site. Check entrance clearance.
Minimum entrance space needed without pallet:
Model 6 & 10:
35
1
⁄
2
in. (902 mm)
Model 1020:
49
5
⁄
8
in. (1262 mm)
Model 20:
39
7
⁄
8
in. (1012 mm)
Model 40:
52
1
⁄
2
in. (1332 mm)
■
Floor at installation site must be level.
■
Cold water line in place. (page 63)
■
2 in. (50 mm) drain connection installed.
■
Max. drain height for floor units: 4 in. (100mm)
■
Electrical power supply/protective measures installed and sized correctly.
(page 60-61)
3) Remove all cartons, packing materials, documents etc. from the interior cabinet.
4) Remove grid shelves/trolley from cabinet.
5) Take unit off the pallet.
■
Moving unit without pallet: Sizes 6, 10, 1020 (Fig. 1)
■
Moving unit without pallet: Sizes 20, 40 (Fig. 2)
Minimum clearance sides and back:
2 in. (50 mm)
Service clearance, left side:
20 in. (500 mm)
Clearance for door opening:
Model 6 & 10:
20
1
⁄
2
in. (521 mm)
Model 1020:
29
1
⁄
2
in. (749 mm)
Model 20:
28
3
⁄
4
in. (730 mm)
Model 40:
30
3
⁄
4
in. (781 mm)
Fig. 1
Fig. 2