Heartland Bakeware 9200/7200 - Manual (Page 21)

21
Power Failure Operation
If electrical power is interrupted in your area, you can still cook meals on your Heartland gas range.
By following these simple directions you will be able to use the burners and oven without the benefit
of electricity.
Caution: make sure your hands and clothing are clear of the burner you are lighting!
Manually Lighting the Top Burners
1) Remove cast grate, for unobstructed access to the
burner head.
2) Hold a flame source to the desired burner head.
We recommend a barbecue lighter to use as a flame
source.
3) Push in and turn the corresponding control knob to
the medium setting.
4) Carefully replace cast grate, keep fingers clear of the
flame.
5) After the burner lights, adjust flame size as required.
Please note that the "auto reignition" feature will not function without electricity, therefore pay close attention to
any burners in use while electrical power is interrupted!
Manually Lighting the Oven Burner
The oven can be operated safely by lighting the oven burn-
er in the following manner:
1) Remove the oven bottom.
2) Hold a flame source at the front of the burner directly
beside the igniter. We recommend a barbecuelighter as
flame source.
3) Push in and hold down the knob, continue to hold down
the oven knob and select the desired oven temperture.
4) You must hold oven knob down for at least 5-6 seconds
after ignition, to activate the oven safety thermocouple.
(releasing the knob too early will extinguish the flame).
5) If the oven flame does not light in 5-6 seconds, STOP.
Release oven knob, this will prevent any further gas
from going into the oven. Wait at least 1 minute before
trying to light oven again. If you arestill not successful
see "trouble shooting guide".
6) Place oven bottom back onto position, Caution
keep fingers and clothing away from the flame!
Please note that the flame sensing auto shutoff feature is still functional without the benefit of electricity so if
for any reason the flame goes out, the gas supply to the oven is shut off automatically!
When lighting top burners manually, set control to
the medium setting to prevent potential injury from
the flame when replacing the grate.
When lighting oven burner manually, light the burner
at the igniter. Keep hands and clothing away from
open flame!
Oven Burner and Igniter
Top Burner Control
Figure 18
Figure 19