Wall mounting – Honeywell DOLPHIN 9951 User Manual
Page 139
13 - 7
Wall Mounting
You need to purchase two wall mount kits that each contain:
• a mounting bracket,
• three screws, and
• six washer/nut sets.
You need two kits so that you have two mounting brackets–one for each end of the device–and enough
screws (4) and washer/nut sets (8).
The mounting bracket contains an open slot between the back and bottom wedges to accommodate the
connector cables.
To Mount Using the Wall Mount Kit
1.
Attach the mounting bracket to the wall using the
2.
On each end of the base, insert a screw into the round end of each of the 4 screw slots on the
bottom panel. Then, slide each screw towards the narrow end of the slot until it snaps in place.
3.
Use a washer/nut set on each of the 4 screws to secure the screw in the slot.
4.
Place the base on the mounting bracket; match the holes up with the secured screws.
5.
Use the remaining washer/nut sets on each of the 4 screws to secure the base to the mounting
bracket.
Recommended Hardware
If a metal or wood stud is present, drill a 3/32 in. pilot hole into the stud and use a #6 X 1 1/2 screw and
washer to attach the bracket to the wall.
For any of the screws positioned so that they are going directly into dry wall, use a sheet rock anchor/
screw set such as the one listed below.
For any of the screws attaching directly into concrete, drill the appropriately sized pilot hole into the
concrete and secure the bracket to the wall using concrete anchor screws such as those listed below.
Wall
Recommended Anchors
Sheet Rock
Buildex E-Z Anchor Stud Solver Medium Duty Drywall Anchor (Model #25216);
supports 50 lbs., screws included
Concrete
Buildex TAPCON concrete anchors 3/16 in. X at least 1 in.