Installing a memory card, Installing a memory card -11, Environmental rating is preserved; see – Honeywell DOLPHIN 9951 User Manual
Page 33
Advertising
3 - 11
Installing a Memory Card
1.
Press the Power key
to put the terminal in Suspend Mode; see
2.
Remove the battery.
3.
Place the terminal on a flat, secure surface with the keyboard face down.
4.
Unscrew both screws and remove the door.
5.
Slide the SD card into the appropriate slot until it clicks into place.
a. To remove an installed SD card, tap on the edge lightly to unlock the card; the card will pop out just
enough for you to grab its edge and pull it out.
6.
Replace the access door and tighten the screws.
There is a rubber gasket on the inside of access door that must be in place when you seal the door.
This gasket performs the sealing action for the door.
Advertising