Honeywell DOLPHIN 9951 - Manual (Page 81)

7 - 3
5. When the IrDA port finds the aligned IrDA port, it immediately starts sending the selected file. The
selected device reads “Sending.”
6. When the file transfer is complete, the selected device reads “Done.”
Receiving Data
The Beam Setting must be set to receive for the terminal to receive data from other infrared devices.
1. Verify that beam settings are set to receive. Tap Start > Settings > Connections tab > Beam. The
Beam Settings window should appear as follows:
2. Align the IrDA ports.
3. Have the owner of the other device send the information to you.
4. Your terminal automatically begins receiving it.
5. A popup message appears asking if you want to receive the incoming file.
6. Tap Yes to receive the file.