Holder C-Trac 4.74 - Manual (Page 74)

149 443 73
C 4.74
Operating instructions
Bild_C232
1 Special operating instructions
Stationary operation
The vehicle can be used for stationary operation, for example,
to drive a water pump via the PTO shaft.
ATTENTION
Place the vehicle n level ground in both di-
rections.
- Attach the stationary equipment to the PTO shaft (1).
- Set the program switch to 0.
- Operate the parking brake.
DANGER
Before switching on the PTO, make sure no-
one is standing in the vicinity of the vehicle
and the rotating PTO shaft.
Removal of hydraulic oil for stationary operation
When the vehicle is stationary, hydraulic oil can be removed,
for example, for the operation of a hydraulic dump.
Max. quantity of oil removed .................................. 12 L
ATTENTION
Before starting to drive after stationary opera-
tion, first check if the power steering is work-
ing. Turn the steering wheel fully to the right
and left several times to release air from the
steering system.