Holder C-Trac 4.74 - Manual (Page 94)

Operating instructions
149 443 93
C 4.74
Operating the implements
3
5
4
2 1
Bild_C212
Flow limiter for joystick
1 Button for individual flow limitation for each individual
joystick function.
- Turn on the main switch for working hydraulics.
The lifting and lowering speed of the power lift can be stored
individually with the flow limitation.
-
Operate the joystick (4) until the desired cylinder
speed is reached, then press button (1).
This value is stored as the maximum speed and it applies
for the full stroke of the joystick.
If the full oil flow is required again, proceed as follows:
-
Move the joystick (4) as far as possible and press
button (1).
The full oil flow is released for the full stroke of the joystick.
Toggle button for Float Position Button
2 Button for setting the joystick button (3) to “float
position of front power lift“
- Press the button (2).
The button (3) is now also activated as float position button
for the front power lift.
Its activation is indicated with two flashing LEDs.
NOTE
You can also toggle the float position on and off
with button (3).
Its activation is indicated with the LED (5).
- Press the button (2) again to toggle the switch.