Holder C-Trac 4.74 - Manual (Page 99)

C 4.74
Operating instructions
98 149 443
Operating the implements
1
Bild_C182
Turning on the front PTO
DANGER
Before turning on the PTO, make sure no-
one is standing close enough to the vehicle
and the driven implement to be hurt.
ATTENTION
Check the mounting angle of the cardan shaft.
Do not start it under 1500 rpm.
- Release the lock at the starting safety switch (1) and
depress the switch. The front PTO is turned on.
- To turn it off, depress the safety switch at the top.
NOTE
If the engine temperature is too high, the PTO
will turn off automatically and an alarm will
sound. The engine must cool at idle speed
before being turned off. Restart the engine
after checking for the cause.
DANGER
After the installed implement is turned off, it
can continue to run. Wait until the implement
is stationary before working on it again.