Heath Zenith 598-1214-03 - Manual (Page 15)

15 598-1214-03
Warning - risk of fire. do not aim
the lamps at a combustible surface within
3 ft. (1 m).
indoor PLug-in ConVerter
Features and Ratings:
• Up to 300 Watt maximum incandescent load.
• No wiring required.
1. Plug in indoor receiver.
2. Plug in light you wish to control.
Caution: do not exceed the maxi-
mum load limits listed above.
3. Check operation. Activate transmitter being
used with receiver (see transmitter instructions).
A signal will be sent to the receiver to turn the
receiver ON or OFF.
4. Using Remote By-Pass Switch. The receiver is
equipped with a remote by-pass switch (see Figure
11). This switch allows the user to select between
AUTO and MANUAL modes. AUTO mode al-
lows the light to be operated by remote control
or remote motion sensor. MANUAL mode allows
the plugged in light to be operated manually.
Caution: do not exceed the maxi-
mum load limits listed above.
10. Check operation. Activate transmitter being
used with receiver (see transmitter instructions).
A signal will be sent to the receiver to turn the
receiver ON or OFF.