Heath Zenith 598-1214-03 - Manual (Page 3)

3 598-1214-03
Note: When operating more than one system
independently of each other, set each system to
a different code. There are 8 codes available by
changing the settings of switches 1 through 3.
Example 2 - Code Switch Settings, System 2
Receiver(s)
Code
Group A
Transmitter(s)
Code
Group Switch
(Group A Selection Shown)
Example 3 - Code Switch Settings with Single
Transmitter
Receiver(s)
Code
Group A
Remote Motion
Sensor Code
When using the wireless motion sensor, the code
and group settings must match receiver(s) for the
system to function properly.
Note: This setting will work independently of exam-
ples 1 and 2 because the code setting is different.
Note: The channel can also be changed to reduce
interference problems from other wireless products
(i.e. wireless phones, garage door openers, etc.). See
Troubleshooting Guide
for more information.
Group A
ON
1 2 3
4
ON
1 2 3
4
ON
1 2 3
4
ON
1 2 3
4