Heath Zenith 598-1214-03 - Manual (Page 9)

9 598-1214-03
Figure 5 - Installing Motion Sensor
installing Motion sensor
1. Install sensor mounting bracket where motion
detection is desired. Attach sensor mounting
bracket to a sturdy object (i.e. tree, post, house,
etc.) using two screws provided (see Figure 5).
Make sure unit has an unobstructed view. Note:
If mounting bracket to a curved surface, attach
mounting bracket vertically.
2. Install motion sensor to mounting bracket. Us-
ing a Philips-head screwdriver, loosen the clamp
screw on the mounting bracket. Insert swivel
ball mount on sensor into mounting bracket
socket (
Note: You should hear a snap). Aim
sensor toward area where detection is desired.
Tighten clamp screw (see Figure 5).
ImporTaNT: The sensor must be mounted with
the bottom cover facing down in order to maintain
water tightness.
Mounting Bracket
Clamp Screw
Nut
Sensor
Mounting Screw
Swivel Ball Mount
Mounting Bracket
Socket