HP DL385 - Manual (Page 49)

Hardware options installation 49
2. Install the hard drive.
3. Determine the status of the hard drive from the hot-plug hard drive LEDs (" Hot-plug SCSI hard drive
LEDs " on page 19 ).
Resume normal server operations.
Removing a hot-plug SCSI hard drive
CAUTION: Always power down the server if the boot partition resides on the drive you are replacing or if
you are replacing the only drive in the server.
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays
are populated with either a component or a blank.
1. Determine the status of the hard drive from the hot-plug hard drive LEDs (" Hot-plug SCSI hard drive
LEDs " on page 19 ).
2. Back up all server data on the hard drive.
3. Remove the hard drive.