HONDA GL1800 - Manual

Honda GL1800 (2001-2005) Audio Amplifier Installation Instructions
This sheet must be read completely to:
1. Provide assistance/clarification to the
installer.
2. Avoid causing injury to installer, customer,
end user, or others.
3. Prevent damage to motorcycle and/or
accessory.
4. Prevent death to customer or other vehicle
operators
.
Installer: Please forward this sheet to the
customer after reviewing it.
5. It is virtually impossible for us to be able to
address every possible situation an installer
or user will encounter. This requires both to
exercise due diligence and to apply some
level of common sense. If you have any
question or problem during the installation,
please contact us as necessary. Read the
instructions completely prior to installation.
90% of questions we receive could be
answered simply by reading the instructions
in their entirety. Phone support will always
provide the quickest response.
Important Information in our instructions
will be provided in the following manner:
6. SHOP TIP: this is information we have
gathered from hands-on installs or customer
feedback.
7. NOTE: important information regarding the
installation.
8. CAUTION: failure to follow instructions
could result in damage to motorcycle and/or
accessory.
9. WARNING: failure to follow instructions
could result in injury or death of operator
and/or passenger or others.
NOTE:
10. "Left", "Right", "Front" and "Rear" are
described from the seated position of the
bike.
11. Check local laws regarding the use of
auxiliary lighting.
12. Use of owner’s manual or service manual is
recommended for installation.
13. If so equipped, place the motorcycle on its
center stand on solid, level ground.
CAUTION:
14. Never route wires or install components that
interfere with the operation of the forks,
handlebars, brake/clutch levers or any other
operational function of the motorcycle.
15. When adding electrical accessories, always
disconnect the battery and properly fuse new
electronics.
WARNING:
16. Allow the motorcycle to cool prior to
installation.
17. When operating engine, allow adequate
ventilation.
18. Never route wires or install components that
interfere with the operation of the forks,
handlebars, brake/clutch levers or any other
operational function of the motorcycle.
19. Never allow your accessories to cause
distractions to remove your focus off the
bikes operation. Never forget that this is a
high-risk sport - don't make it a higher risk
when you don't have to.
20. Never allow your accessories to cause
distractions to others on the road.