Honeywell Dolphin 7900 - Manual (Page 6)

4
Charging
We recommend use of Hand Held Products Li-Ion battery packs. Use of any
non-Hand Held Products battery may result in damage not covered by the
warranty.
The Net Base provides power to the Dolphin terminal to allow the
Dolphin terminal to charge the main battery of the terminal. The
intelligent battery charging system incorporated into all Dolphin terminals
prevents overcharging, which means that Dolphin terminals may be
stored in the Net Base indefinitely without damage to the terminals,
battery packs, or the Net Base.
1. Install the Li-ion battery pack into the back panel of the terminal.
2. Slide the Dolphin terminal into one of the terminal wells until the
Dock LED lights solid green. Charging by the Dolphin terminal
begins immediately if required by the Dolphin terminal.
Connecting the Dolphin Terminal to the Net Base
After the Net Base is installed, configured, and connected to the host
computer, you must connect the Dolphin terminal to the Net Base.
1. Insert a Dolphin terminal into a terminal well.
2. On the Dolphin terminal, tap Start > Power Tools > RASMan. The
RASMan utility initializes.
3. When the connection is established between the Dolphin terminal
and the Net Base, the terminal plays a sound and the
communication icon appears in the Navigation bar.
4. Upon connection, the Dolphin terminal is assigned an IP address
from the Net Base, which can be used by any application on the
Dolphin terminal.
5. When you exit RASMan or remove the terminal from the Net Base,
the terminal plays a sound and the disconnected icon appears in
the Navigation bar.
!