Honeywell Dolphin 7900 - Manual (Page 3)

1
Dolphin Net Base
Quick Start Guide
Introduction
The Net Base enables up to four mobile computers to communicate with
a host device over an Ethernet network.
We recommend use of Hand Held Products peripherals, power cables, and
power adapters. Use of any non-Hand Held Products peripherals, cables, or
power adapters may cause damage not covered by the warranty.
Unpacking the Net Base
Open the shipping box and inspect the package to see that the following
standard items are included:
• One Dolphin Net Base Ethernet cradle
• One universal AC/DC power adapter for the Dolphin Net Base
• One power cord
• One serial extension cable
These are the items you need to set up, configure, and operate the Net
Base. If any items are missing or anything appears to be damaged,
contact your Customer Account Representative.
Keep the original packaging in case you need to return the Net Base for
service or store the Net Base while not in use.
Software Requirements
Before you connect the Dolphin terminal to the Net Base, make sure you
have the most current software installed. To check this, go to Start >
Power Tools > SysInfo.
Applications on the Dolphin Terminal
Applications running on the Dolphin terminal when it is connected to the
Net Base should be designed specifically for a partially connected
network. For more details, please refer to the Best Practices for Partially
Connected Networks document available at
www.honeywell.com/aidc.
!