Honeywell Dolphin 7900 - Manual (Page 5)

3
Power Supply
Setting up the Net Base
1. Make sure the ON/OFF switch on the power adapter is in the OFF
position.
2. Plug the power cord into the power adapter.
3. Plug the power connector cable into the power connector on the
back of the Net Base.
4. Plug the power cord into a standard wall outlet.
5. Plug the CAT-5 Ethernet cable into either of the RJ-45 connectors
on the back of the Net Base.
6. Plug the Ethernet cable into the network.
7. On the power adapter, turn the ON/OFF switch to the ON position.
8. The COMM LEDs on all four slots flash binary codes as the Net
Base finds the DHCP server during the bootloader and kernel
sequences.
Power Cord
ON/OFF
Switch
Power Adapter
Power
Connector
Cable