hussmann P/N 0387183_D - Manual (Page 27)

CARE AND CLEANING
Long life and satisfactory performance of any
equipment is dependent upon the care it receives.
To ensure long life, proper sanitation and mini-
mum maintenance costs, these merchandisers
should be thoroughly cleaned, all debris removed
and the interiors washed down, weekly.
Fan Plenum
To facilitate cleaning, the fan plenum is hinged
and also fastened with screws at each end. After
cleaning be sure the plenum is properly lowered
into position and that screws are reinstalled
OR PRODUCT LOSS WILL RESULT due to improper
refrigeration.
Exterior Surfaces
The exterior surfaces should be cleaned with a
mild detergent and warm water to protect and
maintain their attractive finish. N
EVER USE
ABRASIVE CLEANSERS OR SCOURING PADS .
Always*Clear™ Glass
Wipe inside of glass with isopropyl alcohol and
a soft cloth. Allow surface to dry before closing
door. Use of other cleaners or abrasives may
damage the Always*Clear surface, and/or void
the warranty. Refer to manual that ships with
doors.
Interior Surfaces
The interior surfaces may be cleaned with most
domestic detergents, ammonia based cleaners and
sanitizing solutions with no harm to the surface.
D O N OT U SE :
• Abrasive cleansers and scouring pads, as
these will mar the finish.
• Solvent, oil or acidic based cleaners on any
interior surfaces.
• Ammonia based cleaners on acrylic surfaces.
D O :
• Remove the product and all loose debris to
avoid clogging the waste outlet.
• Store product in a refrigerated area such as a
freezer. Remove only as much product as can
be taken to the freezer in a timely manner.
• First turn off refrigeration, then disconnect
electrical power.
• Thoroughly clean all surfaces with soap and
hot water. D O NOT USE STEAM OR HIGH
WATER
PRESSURE HOSES TO WASH THE INTERIOR .
T HESE WILL DESTROY THE MERCHANDISERS ’
SEALING CAUSING LEAKS AND POOR PERFOR -
MANCE .
• Remove screws and lift hinged fan plenum
for cleaning. B E SURE TO REPOSITION THE FAN
PLENUM AFTER CLEANING MERCHANDISER .
• Take care to minimize direct contact between
fan motors and cleaning or rinse water.
• Rinse with hot water, but do NOT flood.
N EVER INTRODUCE WATER FASTER THAN THE
WASTE OUTLET CAN REMOVE IT .
• Allow merchandisers to dry before resuming
operation.
• After cleaning is completed, turn on power
and refrigerant to the merchandiser.
• Verify that merchandiser is working properly.
Reach-In
P/N 0501904_A 5-1
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
MAINTENANCE
Do NOT use HOT water on COLD glass surfaces.
This can cause the glass to shatter and could
result in personal injury. Allow glass fronts,
ends and service doors to warm
before applying hot water.
WARNING
!
SHUT FANS OFF DURING CLEANING
PROCESS.
WARNING
!