hussmann P/N 0387183_D - Manual (Page 9)

INSTALLING BUMPERS
Offsetting the bumpers and top rails helps to
disguise the joint locations, giving the lineup a
smoother look.
Begin at the left end of the line-up. A starter
bumper is factory-installed with end kits. Insert
the internal joint trim, then add the full-length
bumper.
Align each bumper section with its retainer and
push into place, working from the end of the line-
up. Install full length bumpers and internal joint
trims offset across joints. Make sure that no gaps
exist between sections. Continue installing
bumpers the length of the line up.
Do NOT install the last bumper sections at this
time. These sections will be installed in the last
step.
Once all except the last section of bumper have
been installed, refrigerate the case line-up for
at least six (6) hours. The last sections of
bumper should be kept inside a refrigerated
case or cooler during this time to allow the
bumpers to contract.
Before installing the last full-length section,
measure the remaining space. Use a miter box
and fine-tooth saw to cut last bumper to length.
Install the last section.
Reach-In
P/N 0387183_D 1-5
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
Miter Box
Bumper
Merchandiser
Joint
Full Length
Bumpers
Starter
Bumper
Merchandiser
Joint
Internal Joint
Trims