Operation - al650, Not locked locked al 650 - loading a power chair – Harmar Mobility AL600 User Manual

Page 12

Advertising
background image

Parking the Chair on the Platform: Before
loading the power chair, verify that the
platform has been lowered all the way to the
ground. Set your chair’s speed control at a
slow speed so that you may maneuver
comfortably onto the platform. Drive the
chair onto the platform into the opening of
the docking station.

Raising the Chair: Before raising, verify that
the chair is secured to the platform. While
holding the hand control stand to the side and
away from the lift. Press the up button. The
lift will rai se and retract into the vehicle. The
lift is retracted fully when the platform is fully
inside of the vehicle and the lift’s motion stops.
At this point release the button. Secure the hand
control by placing it on the hook and loop
patch attached to the lift. Close the rear door
carefully taking notice of any baskets,
backpacks or additional items attached to the
chair that may be hit by the door.

Verify Chair is
locked onto
Platform

TO RELEASE CHAIR

Slide knob this direction

To Unload Chair: Lower Platform to the
ground. Push knob as shown to the right.
Drive off chair in reverese. The Docking
Station will automatically reset itself to
accept the next time the chair is loaded.

THREE WAYS TO VERIFY YOUR CHAIR

IS SUCCESSFULLY LOCKED DOWN

1) AUDIBLE "CLICK or POP" SOUND

3) REVERSE TEST

2) VISUAL INDICATOR

The yellow indicator will extend and stay
extended when the chair is

successfully

locked in place.

Attempt to back the chair off the platform.
The chair will NOT move in any direction
when successfully locked.

As the chair enters the locking device,
it should be driven forward until an audible
pop or clicking sound is heard. This sound
is the locking device setting itself around
the chair's docking device pin.

NOTE: During transport, vibration
may cause the chair to tighten itself in
the locking device, making the release
knob difficult to slide. To overcome this,
simply drive the chair forward a bit.
This will take pressure off the knob,
allowing an easier release.

NOT
LOCKED

LOCKED

AL 650 - LOADING A POWER CHAIR

12

Advertising
This manual is related to the following products: