Honeywell Chronotherm IV T8601D User Manual

Mercury notice, Application, Installation

Advertising
background image

® U.S. Registered Trademark
Copyright © 2002 Honeywell •

•All Rights Reserved

INSTALLATION INSTRUCTIONS

69-1410-2

T8601D Chronotherm® IV Deluxe

Programmable Thermostats

APPLICATION

The T8601 Chronotherm® IV Deluxe Programmable
Thermostat provides electronic control of 24 Vac single-

stage heating and cooling systems. Refer to Table 1 for a
general description of the thermostat. All T8601
thermostats require a common wire to supply power.

MERCURY NOTICE

If this control is replacing a control that contains
mercury in a sealed tube, do not place your old
control in the trash.

Contact your local waste management authority
for instructions regarding recycling and the
proper disposal of the old thermostat.

INSTALLATION

When Installing this Product...

1. Read these instructions carefully. Failure to follow

the instructions can damage the product or cause
a hazardous condition.

2. Check the ratings given in the instructions and on

the product to make sure the product is suitable for
your application.

3. Installer must be a trained, experienced service

technician.

4. After completing installation, use these instructions

to check out the product operation.

Location

Install the thermostat about 5 ft (1.5m) above the floor in
an area with good air circulation at average temperature.
See Fig. 1.

Do not install the thermostat where it can be affected by:
— drafts, or dead spots behind doors and in corners.
— hot or cold air from ducts.
— radiant heat from sun or appliances.
— concealed pipes and chimneys.
— unheated (uncooled) areas such as an outside wall

behind the thermostat.

Table 1. Description of T8601 Thermostats.

T8601

System Changeover System Selection Fan Selection

Comments

D

Heat-Cool Automatic

Heat-Off-Cool-Auto

On-Auto

Use keyboard for system and fan selections

Advertising