Hotpoint 50cm Electric Cooker HUE52G - Manual (Page 4)

4
GB
WARNING – THIS APPLIANCE MUST BE EARTHED.
Electrical connection
Electric cookers come without a power supply cable.
The cooker is designed to operate on an electricity
supply which conforms to the electrical data shown
on the Rating Plate. Some cookers can be connected
to the mains only after removing the back panel of the
cooker itself with a screwdriver*.
N.B.: the following installation procedure must be
carried out by a qualified electrician. The electrical
installation must comply with the IEE Regulations,
Building & local By-Lays.
For the installation of the feeding cable carry out the
following operations:
1 Open the terminal board by inserting a
screwdriver into the side
tabs of the cover. Use
the screwdriver as a
lever by pushing it down
to open the cover (see
diagram).
2 Loosen the cable
clamp screw and
remove it, using a
screwdriver as a lever
(see figure).
3 Slacken the wire
contact screws L-N-
, then fasten the wires
under the screw heads,
respecting the colour
code: Black/Blue (N),
Red/Brown (L) and Bare
Wire/Yellow-Green (
).
 Once the connections have been made, tighten all
the terminal screws fully.
 Fasten the supply cable in place with the clamp
and close the cover of the terminal board.
Moving the Cooker
Positioning the Cooker
150 mm
150 mm
650 mm
The height of the
cooker can be
adjusted by means
of adjustable feet in
the plinth (900mm
- 915mm). Adjust
the feet by tilting
the cooker from the
side. Then install the
product into position.
NOTE: This appliance
must not be fitted on a
platform.
The cooker is
designed to fit
between kitchen
cabinets spaced
500mm apart. The
space either side
need only be sufficient
to allow withdrawal
of the cooker for
servicing. It can be
used with cabinets
one side or both as
well as in a corner
setting. It can also be
used free-standing.
Adjacent side walls
which project above
hob level, must not be
nearer to the cooker
than 150mm and
should be protected by heat resistant material. Any
overhanging surface or cooker hood should not be
nearer than 650mm.
Before moving your cooker check that it is cool, and
switch off at the cooker control unit.
Movement of your cooker is most easily achieved by
lifting the front as follows:
Open the grill door sufficiently to allow a comfortable
grip on the underside front edge of the oven roof,
avoiding any grill elements.
Note: Take care in moving the cooker as it is heavy.
Take care to ensure that any floor covering is not
damaged.
Splashplate optional, apply to Parts Department (see
Back Cover for contact number.)
*Concerns certain models only
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24