Connecting the hotsync cable – Handspring Treo 300 User Manual
Page 27
Section 1
Introduction to Your PCS Phone Handspring
®
Treo™ 300
19
In
tro
duc
ti
on
1
Connecting the HotSync cable
The HotSync cable that comes with your PCS Treo 300 enables you to
charge your phone battery and to synchronize the information on your
phone using HotSync technology.
Note:
If your computer does not have a USB port, or it uses Windows 95 or
Windows NT, you need a serial HotSync cable to connect to your
computer. You can purchase a serial HotSync cable from
www.sprintpcs.com.
To connect the HotSync cable:
1.
Connect the travel charger cable to the short end of the Hotsync
cable. Be sure to match the sides of the connectors labeled “UP.”
2.
Connect the USB HotSync cable to a USB port on your computer, or
connect the Serial HotSync cable to a Serial port on your computer.
3.
Connect the long end of the HotSync cable to your phone with the
button facing up.
USB cable and port