Internal backup battery, Internal backup battery -14 – Honeywell DOLPHIN 99EX User Manual

Page 40

Advertising
background image

3 - 14

Battery Error Notification

If your terminal displays the following indicators, replace the main battery pack with a Honeywell Li-poly
or Li-ion battery pack. For information on how to remove the main battery pack from the terminal, see

Replacing the Main Battery Pack

on page

2-3.

appears in the Title bar at the top of the touch screen.

• The General Notification LED flashes red.
• A Notification appears on the Tile bar at the bottom of the touch screen.

Storing Batteries

To maintain top performance from batteries, avoid storing batteries outside of the following temperature
ranges:

• 14°F to 113°F (-10°C to +45°C) for short term storage of less than one month
• 32°F to 86°F (-0°C to +30°C) for long term storage

Do not store batteries in extremely high humidity. For prolonged storage, do not keep batteries stored in
a charger that is connected to a power source.

Guidelines for Battery Pack Use and Disposal

The following are general guidelines for the safe use and disposal of batteries:

• We recommend use of Honeywell Li-ion or Li-poly battery packs. Use of any non-Honeywell battery

may pose a personal hazard to the user.

• Replace defective batteries immediately; using a defective battery could damage the Dolphin terminal.
• Never throw a used battery in the trash. A battery contains heavy metals and should be recycled

according to local guidelines.

• Do not use a battery in any other manner outside its intended use in Dolphin terminals and peripherals.
• Do not short-circuit a battery or throw it into a fire; it can explode and cause severe personal injury.
• Excessive discharge damages a battery. Recharge the battery when your terminal indicates low battery

power.

• If you observe that the Honeywell battery supplied is physically damaged, please send it to Honeywell

International Inc. or an authorized service center for inspection. Refer to the Product Service and
Repair section of this guide.

• Although your battery can be recharged many times, the battery life is limited. Replace it after the

battery is unable to hold an adequate charge.

• If you are not sure the battery or charger is working properly, send it to Honeywell International or an

authorized service center for inspection.

Internal Backup Battery

Located inside the terminal is a 3.6 Volt nickel metal hydride (NiMH) backup battery. The backup battery
prevents the terminal from being reset if you need to replace the main battery pack. It retains RAM data
during the battery pack exchange. A fully charged backup battery provides 30 minutes of backup time.

Note: When removing a battery from the terminal, put the device in

Suspend Mode

(see page 2-10) before removing

the battery door. Once the battery door is removed, wait at least 3 seconds before removing the main battery.
This process allows the device to shut down properly and maintains memory during the battery swap.

Advertising