Honeywell HXMT9 / HXMT9X - Manual (Page 55)

< Figure 33 > VCR System Setup screen.
VCR System Setup
The VCR System Setup screen is used to synchronize the
with your VCR.
There is the BNC for multiplexer input from the VCR.
Set to Off if you are not using the VCR’s
synchronizing trigger pulse. When using your VCR’s synchronizing
trigger pulse, set to match the VCR’s signal; + for positive edge
sensing and – for negative edge sensing.
When On, the buzzer will beep every 20
seconds.
Selecting this brings up a list of VCRs. Select your VCR
from the list. If your VCR is not on the list select User Define.
NOTE : If your VCR has a synchronizing trigger pulse, using it will save
you a lot of time when setting up your system.
• VCR Input :
• External Trigger :
• Panic Rec Buzzer :
• VCR Type :
multiplexer
41
ENGLISH