HoMedics TE-100 - Manual (Page 6)

10 11
2. Press and release the “SCAN” button on the side of the
device. All display symbols will appear for approximately one
second (Figure 1).
3. When the ear thermometer is ready, the display will next
show the results from the last reading. The unit is ready for
measurement at this point (Figure 2).
4. Press and release the “SCAN” button again with the ear
thermometer outside of the ear. An arrow symbol will
appear on the display (Figure 3).
5. Insert the probe tip of the ear thermometer into the ear canal
within two seconds (Figure 4). It is important that the probe
tip be well positioned within the ear canal. Measurement
time for the actual reading is approximately one second.
6. A beep sound will indicate the end of the measurement.
Results of the temperature measurement will be displayed
(Figure 5).
cc
Figure 1
Figure 2
Indicates a
memory
reading
Figure 3
Indicates
measurement
in progress
cc
cc
Figure 4
cc
Figure 5