Havis-Shields Telescoping Computer Base C-TCB-4 - Manual (Page 2)

C-TCB-4-INST-12-04
SUB ASSEMBLY:
1. Confirm receipt of all hardware and components.
2. Loosen or remove front inner and outer passenger seat bolts on vehicle.
INSTALLATION:
1. Mount C-TCB-4 into vehicle
• Slide pole support assembly between front inner seat base mount and floor of vehicle.
• Loosely attached factory seat bolt.
• Slide lateral support brace between front outer, seat base mount, and floor of vehicle.
• Attach lateral support brace and side support brace to welded tab on side of pole
support assembly and loosely attach using 5/16-18 Hex head bolt, washers and nylock
nut.
• Position assembly on passenger seat base and completely tighten factory seat bolts.
• Mount side support brace to vehicle using ¼” x ¾” Hex head lag bolts. A 3/16” pilot
is required.
Note: When mounting side support brace to floor of vehicle, be sure to check for obstructions prior to
drilling or lag bolting to floor.
• Mount optional C-3090, computer-mounting platform, to telescoping pole assembly
using hardware and instructions provided with C-3090.