Hunter Fan ICC-801PL - Manual (Page 10)

6
MOUNTING THE CONTROLLER TO WALL ..........................................................................
ICC Controller
Plastic Cabinet
Screw with
Screw Anchor
Cutaway View
Wall Mount for Plastic, Metal or Stainless Steel Cabinet
All necessary hardware is included for most installations.
1. Select a location as close as possible to a standard electrical outlet
that is not controlled by a light switch.
2. Using the enclosed mounting template, mark the hole locations on
the wall. It should be in an easily accessible location at eye level
if possible.
3. Drill a 3 /
8
" (10 mm) hole at each mark.
4. Install screw anchors into holes if attaching controller to drywall,
masonry, or plaster walls.
5. Remove the door and front panel from the controller. The front door
can be removed by pulling out the hinge pin.
6. Remove the protective plastic covering from around the appropriate
mounting bosses on the back of the controller cabinet by pushing a
screwdriver through them.
7. Holding the controller cabinet, line up the holes in the cabinet with
the wall anchors or pilot holes.
8. Drive a screw through each hole and secure snugly but do not
over tighten.