Hunter Fan ICC-801PL - Manual (Page 30)

26
PROGRAMMING THE CONTROLLER (continued) ..............................................................
RUN
RUN
After programming is complete,
turn the dial to RUN to enable
automatic execution of all selected
programs and start times. Watering
will not occur unless dial is in the
RUN position.
WEATHER SENSOR
BYPASS
With this built-in feature,
there is no need for an
additional manual bypass
switch when using rain
sensors (the ICC works
with the Hunter Mini-Clik
® , plus some other rain, wind, and freeze
sensors on the market today). If the system is preventing system
operation (or no sensor is installed and the switch is in the ON
position), SEN OFF will be displayed. Simply move the switch to OFF
and the weather sensor will be bypassed. This allows you to use the
system.
MANUAL SINGLE
STATION
SYSTEM OFF
SYSTEM OFF
Valves currently watering will be
shut off after the dial is turned to
the SYSTEM OFF position for two
seconds. All active programs are
discontinued and watering is
stopped. To return controller to
normal automatic operation,
simply return dial to RUN position.
MANUALLY RUN A SINGLE STATION
1. Turn the dial to the MANUAL-
SINGLE STATION position.
2. Station run time will flash in
the display. Use the button
to move to the desired station.
You may then use the
and
buttons to select the
amount of time for a station
to water.
3. Turn the dial to the RUN
position to run the station
(only the designated station
will water, then controller will return to automatic mode with no
change in the previously set program).
MANUAL ALL
STATION
MANUALLY RUN ALL STATIONS
1. Turn the dial to MANUAL-ALL
STATIONS.
2. You can select program A,
B, C, or D by pressing the
button.
3. Press the button until
desired starting station is
displayed.
4. Station run time will flash in
the display. Use the and
buttons to select the amount of run time for the station to water
if different from the run time displayed.