Handspring VisorPhone - Manual (Page 109)

Warranty and Other Product Information 103
Safety and General Use While Driving
Check the laws and regulations on the use of telephones in the area where you drive. Always obey them.
When using the phone while driving, please:
■ Give full attention to driving and to the road
■ Use hands-free operation, if available
■ Pull off the road and park before making or answering a call if driving conditions so require.
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio fre-
quency energy and, if not installed and used in accordance with the instructions, may cause harmful inter-
ference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
■ Reorient or relocate the receiving antenna.
■ Increase the separation between the equipment and receiver.
■ Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
■ Consult the dealer or an experienced radio/TV technician for help.
The use of shielded I/O cables is required when connecting this equipment to any and all optional peripheral
or host devices. Failure to do so may violate FCC rules.
Caution: Changes or modifications not covered in this manual must be approved in writing by the manu-
facturer's Regulatory Engineering Department. Changes or modifications made without written approval
may void the user's authority to operate this equipment.