Honeywell NXL - Manual (Page 47)

✞ ✟ ✠ ✡ ☛ ☞ ✡ ✌ ✌ ✞ ✟ ✠ ✡ ☛ ☞ ✡ ✌ ✌ ✞ ✟ ✠ ✡ ☛ ☞ ✡ ✌ ✌ ✞ ✟ ✠ ✡ ☛ ☞ ✡ ✌ ✌ Cabling and connections 47(96)
6
6.2.5.1
Jumper selections on NXL basic board
The user is able to customise the functions of the frequency converter to better suit his needs by selecting
certain positions for the jumpers on the NXL board. The positions of the jumpers determine the signal type
of analogue input (terminal #2) and whether the termination resistor RS485 is used or not.
The following figures present the jumper selections of NXL frequency converters:
Figure 6-22. Jumper selection for NXL, MF2 and MF3
nxlk15.fh8
Jumper block X 4 in M F3 :
Voltage input; 0...10V
Termination resistor RS 485 is in use
0...20mA; Current input
Voltage input; 0...10V
= Factory default
0...20mA; Current input
Termination resistor RS 485 is not used
Jumper block X 4 in M F2 :
Jum per block X 7 in M F3 :
Termination resistor RS 485 is in use
Termination resistor RS 485 is not used
Termination resistor
programming
Analogue input
programming
Analogue input
programming
Termination resistor
programming