Honeywell NXL - Manual (Page 60)

60(96) Control Keypad Honeywell Honeywell Honeywell Honeywell
7
7.4.2 Parameter menu (P2)
Parameters are the way of conveying the commands of the user to the frequency converter. The
parameter values can be edited by entering the Parameter Menu from the Main Menu when the
location indication P2 is visible on the display. The value editing procedure is presented in Figure 7-
6.
Push the Menu button right once to move into the Parameter Group Menu (G#). Locate the
parameter group desired by using the Browser buttons and push the Menu button right again to
enter the group and its parameters. Use again the Browser buttons to find the parameter (P#) you
want to edit. Pushing the Menu button right takes you to the edit mode. As a sign of this, the
parameter value starts to blink. You can now change the value in two different manners:
1 Just set the new desired value with the Browser buttons and confirm the change with the Enter
button. Consequently, the blinking stops and the new value is visible in the value field.
2 Push the Menu button right once again. Now you will be able to edit the value digit by digit.
This editing manner may come in handy, when a relatively greater or smaller value than that
on the display is desired. Confirm the change with the Enter button.
The value will not change unless the Enter button is pushed. Pressing the Menu button left
takes you back to the previous menu.
Several parameters are locked, i.e. not editable, when the drive is in RUN status. The frequency
converter must be stopped in order to edit these parameters.
The parameters values can also be locked using the function in menu S6 (see Chapter 7.4.7.2).
You can return to the Main menu anytime by pressing the Menu button left for 1—2 seconds.
The basic parameters are listed in Chapter 8.3. You will find the complete parameter lists and
descriptions in the HVAC and Multi-Control Application manuals.
Once in the last parameter of a parameter group, you can move directly to the first parameter of that
group by pushing the Browser button up.