Honeywell VRX180 - Manual (Page 197)

Setpoint Profiler
Video Recorder – User Manual 183
Segment Events
Each segment contains 16 programmable discrete event outputs whose ON/OFF states- specified by
you -can be used to trigger other discrete functions. The segment’s event states are activated at the
beginning of the segment and are maintained unless changed by the next segment in the profile. See
Table 5-1 . The last segment’s event states are maintained after the profiler is ended.
Table 5-1 Example of Segment Events
Segment #1 Segment #2 Segment #3
Event 1 State 1 (ON) 0 (OFF) 0 (OFF)
Event 2 State 0 (OFF) 1 (ON) 0 (OFF)
Event 3 State 1 (ON) 0 (OFF) 1 (ON)
To activate events in the middle of a ramp segment, replace the desired segment with 3 segments: a
ramp, a very short soak, and another ramp. Program the second and third segment events as if they
were the middle of the segment.
To activate events here
Program this: Short soak segment
with desired events
Ramp segment
Same events as short soak
Ramp segment
Program both ramps with same slope.
Figure 5-8 Activating Events In Mid-Segment