Honeywell VRX180 User Manual
Page 205
Setpoint Profiler
Video Recorder – User Manual
191
Setpoint Profiles Menu (in Online mode)
This menu lets you define profile ramp and soak segments and associated parameters, and store and
load programs to and from floppy disk or memory. See Figure 5-13 for allowable and non-allowable
storage.
To access the Setpoint Profiles menu:
1. Press the Menu button until a main menu is displayed.
2. Select Set Mode and change the mode to Online.
3. Select Setpoint Profiles.
4. Select a profile (#1 through #4) to program.
Table 5-5
,
Table 5-6
and describe the Setpoint Profile prompts.
Table 5-4 Setpoint Profiles Prompts
Prompt
Range/Selections
Definition
EDIT PROFILE #1
EDIT PROFILE #2
EDIT PROFILE #3
EDIT PROFILE #4
Select a profile to edit. See Table 5-5 for
prompts.
STORE PROGRAM TO
DISK
STARTING PROFILE #
Select 1-4.
Select the lowest numbered profile to be
stored; that is, Profile 1, 2, 3, or 4. See How
programs are stored on a disk on page 200
for details.
NUMBER OF PROFILES
Select 1-4.
Number of profiles (1, 2, 3, or 4) determines
how many profiles will be stored, starting with
the Starting Profile #. For example, if Starting
Profile # is 1 and Number of profiles is 3,
then Profiles 1, 2, and 3 are stored. See How
programs are stored on a disk on page 200
for details.
FILE
Select the filename and number. Filename
extension is .LNS. After you select the
number and press Enter, the profile(s) are
stored to disk.
FILES ON DISK
Lists all files on the disk.
STORE PROGRAM TO
MEMORY
PROGRAM NUMBER
Select 1-12.
There are up to 96 “slots” allotted for profile
memory storage. Depending on how many
profiles your instrument has, each program
will contain a certain number of profiles. See
How programs are stored to memory on page
198 for details.
STORE PROGRAM TO MEMORY
Select this to store program to memory.