Honeywell HJZTP - Manual (Page 28)

Rev. 1.01 18 900.0570
8-Sept-05
4.4 PICTURE CONTROL
The following table indicates the keys used for picture control:
Key Function
display Display
sequence Sequence
freeze Freeze
Press the ‘display’ key to select the next display setting (in the cycle of ‘4x4’, ‘3x3’, ‘2x2’
and ‘PIP’).
Use the F3 (◄) and F4 (►) keys to cycle through the other cameras when displaying 2x2
and
3x3 displays.
The screen layout of the multi-camera displays can be set by pressing the ‘F5’ (‘enter’)
key, then ‘F1’ (‘’), ’F2’ (‘’), ‘F3’ (‘’) or ‘F4’ (‘’) keys to select an active cameo
(highlight box displayed). Then press one or two of the number keys (to enter a legal
camera number) followed by the ‘camera’ key to select that number camera to be
displayed in that cameo.
Press the ‘sequence’ key to put the DVR output into a sequence (the sequence depends
on the current display mode and set-up). If the key is pressed again, the sequence stops
(displaying the current step in the sequence).
Press the ‘freeze’ key to freeze the current display. Press the key again to return to the
‘live’ picture(s).
4.5 CAMERA SELECTION
Press one or two of the number keys (to enter a legal camera number) followed by the
‘camera’ key to select that number camera for full-screen display on the DVR output.
This also selects the associated DVR.
Press the ‘camera’ key by itself to increment the camera selection by one.
Note: Both of the above selection processes also make the displayed camera the
controlled camera as shown on the keyboards LCD display. The controlled camera can
be changed independently of the DVRs displayed camera(s) by putting the keyboard in
PTZ mode. To enable/disable PTZ mode, press and hold the ‘Fn’ key , then press the
‘mode’ key. When in PTZ mode the PTZ LED will be on
4.6 DVR SELECTION
Pressing a number followed by the ‘Fn’ key selects a DVR to control. This also selects
the last camera controlled on that DVR (or the first camera input on that DVR if it has not
been selected previously).