Heath Zenith Wireless Push Button Accessory 598-1105-06 - Manual (Page 3)

-- 598-1105-06
Code and Tune Settings
Code Settings
Note: Most installations will not require you to change any jumpers
or dip switch settings on your chime and push button.
WARNING: Disconnect chime unit from power source before opening
code access door. Close door and replace screw before reconnecting
to power (if applicable).
The push button and chime communicate by using a code that can be
changed by switching dip switch positions (or removing and/or adding
jumpers) on both the push button and chime. The code is factory set;
however, there are 128 selectable codes that allow you to expand your
system and prevent outside interference. Other wireless products may
cause interference and the system may not function properly. Follow the
instructions below for setting a new code.
1. Unplug wireless chime (if applicable).
2. Open the cases and locate the jumpers or dip switches on both the
push button and chime (See illustrations on pages 5 and 6).
. The push button and chime both have eight different jumper/dip switch
locations. Positions 1 through 7 are used for setting the code.
4. To change the code, add and/or remove jumpers or change dip switch
setting as needed. It is recommended to only change one setting at
a time and then check to see if system is functioning properly.
Note: Positions 1 through 7 must be exactly the same for both the
push button and chime for this system to function.