Heath Zenith Wireless Mechanical Chime User Manual

Wireless mechanical chime

Advertising
background image

This package includes (Style of push button and chime may vary from illustration):
• Wireless chime
• Wireless push button w/battery (Specific models include 2)
• Hardware pack
This device is for use with 120VAC, 60 Hz. Do noT exceeD recom-
menDeD volTage.

Wireless Mechanical

Chime

© 2007 Heathco llc

598-1123-02

Figure 2

Figure 1

1. Install two lithium type CR1220 3 volt push

button batteries (included). remove back of
case by pushing in tab on bottom with a small
screwdriver. make sure batteries are oriented
properly (see page 3).

2. Locate an approved, vertically mounted,

single gang, rectangular electrical box in
the wall.
It is recommended that the chime be
located approximately six (6) feet above the floor
for best sound travel and appearance.

WARNING: Turn power off at circuit

breaker or fuse.

3. Run wiring to electrical box using approved

wiring. connect the two wires from the house
wiring using supplied Ul approved wire nuts.
connect the black wire from chime to the black
wire from house. connect the white wire from
chime to the white wire from house.

4. Mount chime and push button. attach chime

unit to rectangular electrical box using two
screws provided. Insert screws into screw holes
as shown in Figure 2. Note: chime can only be
mounted in vertical position. Use arrow on rear
of chime unit as a guide. Turn on household
power.

Advertising