HP Officejet 6500A Plus - Manual (Page 128)

Media is not coming out correctly
•
Make sure the output tray extender is fully extended; otherwise, printed pages may
fall off the printer.
• Remove excess media from the output tray. There is a limit to the number of sheets
the tray can hold.
Pages are skewing
•
Make sure the media loaded in the trays is aligned to the paper guides. If needed,
pull out the trays from the printer and reload the media correctly, making sure that
the paper guides are correctly aligned.
• Load media into the printer only when it is not printing.
Multiple pages are being picked up
•
Fan the media before loading.
• Make sure the paper guides are set to the correct markings in the tray for the
media size you are loading. Also make sure the guides are snug, but not tight,
against the stack.
• Make sure the tray is not overloaded with paper.
• When using thin special media, make sure that the tray is completely loaded. If you
are using special media that is only available in small quantities, try placing the
special media on top of other paper of the same size to help fill the tray. (Some
media is picked up more easily if the tray is full.)
• If you are using thick special media (such as brochure paper), load media so that
the tray is between 1/4 and 3/4 full. If necessary, place the media on top
of other paper of the same size so that the stack height is within this range.
• Use HP media for optimum performance and efficiency.
Solve copy problems
If the following topics do not help, see HP support for information about HP support.
•
No copy came out
• Copies are blank
• Documents are missing or faded
• Size is reduced
• Copy quality is poor
• Copy defects are apparent
Chapter 8
124 Solve a problem