Honeywell TE831W-2 - Manual (Page 9)

9
E. WIND CUPS SHAFT
Holds wind cups on the anemometer arm
F. BATTERY COMPARTMENT
Holds 2 AA-size batteries
G. WALL MOUNT SCREW OPENINGS
Allows securing the anemometer in place
H. BATTERY COVER
Secures battery compartment on the anemometer base
Assembly
• Slide the wind cups on to the anemometer rotating shaft. Do not use force.
• Insert the longer arm of the Allen Wrench (provided) into the wind cup set screw opening. Feel the head of the set
screw inside the wind cups and tighten carefully the set screw securing the wind cups to the rotating shaft.
• Test to ensure cups are securely fastened to the shaft and cannot be removed
Battery installation
• Remove four (4) screws from the battery compartment with a small Phillips screwdriver.
• Open the battery compartment and install 2 “AA” size alkaline batteries (not included) matching the polarities shown.
• Do not close battery compartment yet as you need to make sure that the anemometer sends the signal to the main
E
F
G
H
B
D
C
A