Husqvarna DM 340 - Manual (Page 10)

10 – English
STARTING AND STOPPING
Before starting
Make sure that:
• Power switch, cord and electrical outlet are intact. If not,
they must be replaced by an authorised repairman.
• Cooling air vents are not blocked.
• The machine and its equipment are correctly installed.
• The stand is properly fixed and that the drill is properly
mounted on the stand.
• The drill is secured properly.
• Water cooling is undamaged and connected to the
machine.
• Use suitable drill bits depending on whether water or dry
drilling is being performed. In the event of uncertainty
contact your dealer, your service workshop or an
experienced operator.
• Prevent unintentional starting. Ensure the switch is in the
OFF-position before connecting to power source.
Starting
1 Set the working speed by turning the drill spindle and at
the same time move the gear knob to the required
position.
2 Turn on the water cooling.
3 Start the machine by switching on the on-off switch.
Also press, if desired, the Smartstart TM button.
Stopping
Switch the on-off switch off to stop the machine.
Cooling
Run the machine unloaded for a minute or two to cool the
motor.
!
WARNING! Note the following before
starting:
The machine should be connected to an
earthed outlet socket.
Check that the mains voltage corresponds
with that stated on the rating plate on the
machine.
Ensure you stand firmly. Keep people and
animals well away from the working area.
IMPORTANT! Changing gear may only be done when the
machine is switched off. Otherwise there is a risk of
damaging the gearbox.
!
WARNING! The drill bit continues to rotate
for a while after the motor has been switched
off.
Do not stop the drill bit with your hands.
Personal injuries can occur.