Set the default fax reprint settings, Create stamp-received faxes, Block or unblock fax numbers – HP CM1312 MFP Series User Manual
Page 135
NOTE:
Make sure that the default media size setting matches the size of the media that is loaded in
the tray.
1.
On the control panel, press
Setup
.
2.
Use the arrow buttons to select Fax setup, and then press
OK
.
3.
Use the arrow buttons to select Advanced setup, and then press
OK
.
4.
Use the arrow buttons to select Fit to page, and then press
OK
.
5.
Use the arrow buttons to select On or Off, and then press
OK
to save the selection.
Set the default fax reprint settings
The default fax reprint setting is On. To change this setting from the control panel, complete the following
steps:
1.
On the control panel, press
Setup
.
2.
Use the arrow buttons to select Fax setup, and then press
OK
.
3.
Use the arrow buttons to select Advanced setup, and then press
OK
.
4.
Use the arrow buttons to select Allow Fax Reprint, and then press
OK
.
5.
Use the arrow buttons to select On or Off, and then press
OK
.
NOTE:
To reprint a fax, see
Create stamp-received faxes
The product prints the sender identification information at the top of each received fax. You can also
choose to have your own header information included on each received fax to confirm the date and time
that the fax was received. The factory-set default for stamp-received faxes is Off.
NOTE:
This option applies only to received faxes that the product prints.
1.
On the control panel, press
Setup
.
2.
Use the arrow buttons to select Fax setup, and then press
OK
.
3.
Use the arrow buttons to select Advanced setup, and then press
OK
.
4.
Use the arrow buttons to select Stamp faxes, and then press
OK
.
5.
Use the arrow buttons to select On or Off, and then press
OK
to save the selection.
Block or unblock fax numbers
If you do not want to receive faxes from specific people or businesses, you can block as many as 30
fax numbers by using the control panel. When you block a fax number and someone from that number
sends you a fax, the control-panel display indicates that the number is blocked, the fax is received and
discarded. The fax does not print, and is not saved in memory. Faxes from blocked fax numbers appear
in the fax activity log with a “discarded” designation. You can unblock blocked fax numbers individually
or all at one time.
NOTE:
The sender of a blocked fax is not notified that the fax failed.
ENWW
Change fax settings 123